Ensuring that the bearings of the vibrating feeder are properly lubricated is crucial for maintaining the normal operation of the equipment. The following are some key measures to ensure proper lubrication:
Select the appropriate lubricant: It is determined based on the usage location and temperature conditions. Generally, gear oil is used. Lubricating oil should be determined based on the location of use and temperature conditions. Generally, gear oil is used. It is necessary to ensure that the thin oil level in the vibrator is higher than the oil gauge height (filled through the elbow of the joint). The oil must be replaced every 3 to 6 months. When changing the oil, the oil tank, bearing raceways and gear surfaces should be cleaned with clean gasoline or kerosene.
Regular lubrication: During use, molybdenum disulfide 2 grease should be regularly added to the bearings. Add it once every two months, once a month in high-temperature seasons, and then remove it once every six months. Once the motor is in operation, replace the internal bearings.
Cleaning and lubrication: Clean the oil injection port before refilling to prevent impurities from mixing in. Regularly replace the old grease to avoid oxidation and deterioration.
Lubrication system maintenance: Install labyrinth seals or lip seals to prevent dust and moisture from entering the bearing cavity. For the circulating lubrication system, regularly check the oil pump pressure, the condition of the filter and the smoothness of the pipeline.
Bearing selection and matching: Choose high-temperature resistant bearings (such as ceramic bearings, high-temperature alloy steel bearings) based on the equipment’s rotational speed, load, and temperature. For instance, the C3/C4 series bearings feature a larger clearance and are suitable for high-temperature environments.
Precise installation technology: Centering adjustment: Use a dial indicator to check the coaxiality of the shaft and the bearing housing. The deviation should be ≤0.02mm to prevent eccentric operation. Hot installation specification: Heat the bearing to 80-100℃ and install it quickly to avoid local overheating and deformation. It is strictly prohibited to strike directly with a hammer. A copper rod or induction heater should be used in conjunction.
Control the load and operating conditions: Control the load and operating conditions to avoid overloading operation, as this not only damages the bearings but may also affect the overall performance of the lawn mower.
Through the above measures, it can effectively ensure that the bearings of the vibrating feeder are properly lubricated, thereby extending the service life of the equipment and ensuring its normal operation.
Post time: Jul-02-2025