Impact Crusher Parts — Blow Bar

Short Description:

The blow bar is mainly used in the impact crusher of mining equipment. It has good toughness and good deformation hardening ability, and is widely used in mining, smelting, building materials, highways, railways, water conservancy and chemical industries. The blow bar is a vulnerable part of the impact crusher and an important component of the impact crusher; The most consumable vulnerable part in the production is the blow bar.

Product Detail

Product Tags


Main materials: high chromium alloy, composite steel, etc.
Production process: sodium silicate sand casting, super large square meter heat treatment pool, etc.
Applicable materials: river pebble, granite, basalt, iron ore, limestone, quartz, iron ore, gold mine, copper mine, etc.
Scope of application: sand and stone quarry, mining, coal mining, concrete mixing plant, dry mortar, power plant desulfurization, quartz sand, etc.

product description

Quality assurance: The optimized heat treatment process makes the product even in hardness and stronger in impact and wear resistance. Each link of casting production has strict control procedures, which must be reviewed and confirmed by WUJ Quality Inspection Department before leaving the factory to ensure the quality of each outgoing product.

Technical guarantee: the WUJ blow bar is made of high chromium alloy or special ingredients according to the working conditions, with fine workmanship and product innovation, and has absolute quality advantages over the products of the same industry. WUJ has a number of professional technical support and high-end professional on-site mapping equipment, which can be configured according to customer personalized requirements. After scientific and strict smelting, casting and heat treatment processes, the products can not only greatly improve the wear resistance, but also improve the beauty of the broken materials.

High cost performance ratio: the use of high chromium composite blow bar doubles the production efficiency of the crusher, reduces the investment cost of casting wear, reduces the shutdown loss caused by frequent replacement of parts, and greatly improves the return on investment.

Note that the blow bar is the main wear part of reverse fracture. After each shutdown, observe its wear through the inspection door, especially the leakage surface. In case of wear or unidentifiable causes, please replace them in time, or contact WUJ Company to ask for professional suggestions or solutions.

  • Previous:
  • Next:

  • Write your message here and send it to us